dome z wave

the dome z-wave plus shutoff valve is the ultimate safety and prevention smart tool — it automatically shuts off your water/gas main when leaks, floods, or pipe bursts are detected by your connected z-wave sensors. once the device is included to your z-wave gateway controller, receive text/email alerts if the valve has been activated. the dome shutoff valve installs directly over your existing valve, and only requires a single phillips screwdriver to mount. the dome shutoff valve also features a built-in range extender and the latest in z-wave plus technology, so rest assured you’re always covered. note: when the valve is successfully included, the motor will start turning automatically.

to include the valve into your z-wave network: 1. put your z-wave gateway controller into inclusion mode. 2. plug the valve into an outlet within direct range of your controller, less than 10 feet. before mounting the valve, be sure you’ve found a place where you can position it appropriately and within range of your z-wave gateway controller. make sure the valve handle and open/close button can be fully and easily accessed from its position — it should be at least 5” away from walls and obstructions. it must also be within 10 feet of a power outlet to ensure the included power cord can reach.

this device and every other certified z-wave device can be used together with any other certified z-wave device regardless of brand and origin as long as both are suited for the same frequency range. if a device supports secure communication it will communicate with other devices secure as long as this device provides the same or a higher level of security. please make sure to reset the device into factory default. the device needs to be added to an existing wireless network to communicate with the devices of this network.

this device is battery operated and turned into deep sleep state most of the time to save battery life time. this device will wakeup regularly and announce the wakeup state by sending out a so called wakeup notification. this parameter sets the total amount of time the leak sensor will beep and light its led in the event of a leak (see figure 5.) size: 1 byte, default value: 1 this parameter enables or disables the leak sensor – if disabled, the device will not respond in any way to detected leaks.

z-wave is a technology that uses a certain radio frequency to communicate with other devices. one of the best features about z-wave products is that they this product has tremendous flexibility, and has the potential to provide a chime and siren with 10 different tones and 3 different volume levels. it can mount dome is a line of easy to use z-wave products designed to work with your favorite dome home automation leak sensor – wireless z-wave plus with remote, dome z wave plus, dome z wave plus, z-wave valve control, dome z-wave plus door/window sensor, z-wave siren.

the dome z-wave plus shutoff valve is the ultimate safety and prevention smart tool — it automatically shuts off your water/gas main when leaks, floods, dome leak sensor dome now officially works with wink! the dome home automation wireless z-wave leak sensor with remote probe helps you cap leaks before they the flood sensor should be within 10 of your z-wave controller for the inclusion dome home automation z-wave devices give your family peace of mind and, z-wave chime, dome siren, dome motion sensor, z-wave valve actuator, dome by elexa, dome siren smartthings, dome products, dome siren manual, dome dms01, dome siren outdoor.

When you try to get related information on dome z wave, you may look for related areas. dome z-wave plus, z-wave valve control, dome z-wave plus door/window sensor, z-wave siren, z-wave chime, dome siren, dome motion sensor, z-wave valve actuator, dome by elexa, dome siren smartthings, dome products, dome siren manual, dome dms01, dome siren outdoor.